Trajectory View

Prairiewolf · Rookie Member Joined: Jun 05, 2011 Posts: 3 Location: Utah

I love this PointBlank and I use it often. I have just one question regarding the Trajectory View. It always shows trajectories for about 10 different calibers displayed on the screen at the same time. I can tell them apart because they're all different colors, but is there a way to only get the trajectory display for the load I selected? Am I doing something basically wrong?

Ominivision1 · Posted: Tue Feb 26, 2013 2:35 pm Post subject: Re: Trajectory View

Bumping this up in case Dallan didn't see it.

DallanC · Site Admin Joined: Jan 18, 2005 Posts: 3572 Location: Utah

Prairiewolf wrote:

I love this PointBlank and I use it often. I have just one question regarding the Trajectory View. It always shows trajectories for about 10 different calibers displayed on the screen at the same time. I can tell them apart because they're all different colors, but is there a way to only get the trajectory display for the load I selected? Am I doing something basically wrong?

Interesting, in all these years this is the first comment I have had on this. It basically draws a trajectory for all "loads" that are valid. You could invalidate any of them currently to get them to not draw (ie: set something like the bullet weigh to 0.

I can see if I cant add a checkbox for each load tab page to draw it or not.

-DallanC

Prairiewolf · Rookie Member Joined: Jun 05, 2011 Posts: 3 Location: Utah

OK, thanks Dallan, I'll do that. That'll help a lot.

DallanC · Site Admin Joined: Jan 18, 2005 Posts: 3572 Location: Utah

Bumping this.

You can disable any trajectory from drawing by changing the trajectory's color... there is an option there to not draw it.

-Dallanc

Prairiewolf · Rookie Member Joined: Jun 05, 2011 Posts: 3 Location: Utah

Ah, that'll work great. Thanks so much!