Hi Folks. Just ran some tests on some of your suggested loads and put the results on the table below:

CARTRIDGE: 3006 SPRINGFIELD MAXIMUM CASE TRIM: 2.494”
RIFLE: BROWNING FN SAFARI MAXIMUM COAL: 3.340”
BARREL: 22 INCHES RELOADING DIES/CRIMP: LEE
CASES: WINCHESTER PRIMERS: WLR. WLRM

LEE DIPPERS AND CAPACITIES OF SELECTED POWDERS:
DIPPER POWDER
VARGET H4350 IMR4831 IMR4350
#3.1 42.4 GRAINS ---GRAINS ---GRAINS ---GRAINS
#3.4 46.5 GRAINS GRAINS 46.3 GRAINS 46.3 GRAINS
#3.7 50.6 GRAINS GRAINS 50.3 GRAINS 50.3 GRAINS
#4.0 54.7 GRAINS GRAINS 54.4 GRAINS 54.4 GRAINS
#4.3 58.3 GRAINS GRAINS 58.5 GRAINS 58.5GRAINS

RELOADING DATA: Hornady 165 Grain Spitzer Point
POWDER/ PRIMER LOAD IN GRAINS FEET PERSECOND FOOT POUNDS @ 300 YARDS PRESSURE
IMR4350/WLR/WLRM 55 2650 ---- No signs
56 2745 ---- “
57c 2806 1800 “
57c M 2850 1800 “
60 2900+ 1944+ N/A

H VARGET/WLR/WLRM
52 2900 1900+ No signs
52.5 2917 1900+ “
*53 M 2945 1900+ “
54 “

IMR4831/WLR 56 2894 1800 56,000 PSI
57 N/A
58 N/A
c =’s COMPRESSED LOADS
M =’s MAGNUM PRIMER (Chosen as volume is over 50 grains and will be used in sub-zero temperatures.