Search found 9 matches

spider,
Bushmaster has given you the best advice, if you are using RCBS case lube, wash out your dies with very hot water and an appropriate sized nylon/cotton bore brush/mop. If you're using a spray ...

Lester,
The answer you need is this.
All this about 'into' or 'just off' the lands is hogwash!

Most, if not ALL hunting bullets work best when there is a 'jump' of between .015"-.100", and quite ...

Lester,
One word of caution here,[u] NEVER [/u]reduce the starting loads listed in any manual, no matter what advice you may have been given.

The solution to your problem is quite simple:
Use wha ...

Hey guys,
Trying to find some info for my 25-06 with 87grHP bullets and either H4350 or RE19/22. Anyone with old tested data would be a great help.
Have lost all my old tested data for these bullets ...

Chainsaw,
Love the handle!
I'm in Australia and own a couple of 300 winnies.
I use mine on roo's quite often with Nosler 150gr Ballistic Tips, I have used the 125gr Ballistic Tips, but some big buc ...

I noticed that few addressed what you said in your post about 'keyholing' the target at 200yds.
The simple answer is that your rifle hasn't got a fast enough twist to stabilise those long 62gr bulle ...

I have found quite a few powders that give similar accuracy; H4831sc, RE19, RE22 and RE25. (RE19 gave the slowest velocities in all bullet weights.)
Of all tested, RE25 gave the highest velocity with ...

[quote="DallanC"]I immediately cancelled a magazine subscription where they advocated the "Texas heart shot" as a good shot when the animal is facing directly away.

-DallanC[/quote]
I will always ...

I would try using RL22 and if that doesn't perform adequately, I would go for RL25. I use Federal 215 match primers for all loads in the 300WM.
I also use Remington brass for general hunting, which ...