Search found 5 matches

There isn't a way in PointBlank that I know of to change printer settings. A workaround is to go into your computers Control Panel and into the Printers and Faxes, make sure the printer you want to u ...

First off, I want to say that this software rocks! I took my first shots at 1000 yds this weekend with impressive results. I had printed out a couple of PB table data (1 for 100yds and 1 for 300yds) ...

Thanks for checking. I won't be home till later to see the example I was looking at, but if 1 MOA =1.047", then the inches should always be higher than the MOA right?

Did you get a chance to verify the calcs in the MOA table?

I may be misunderstanding how to use the MOA table, so hopefully someone can clear something up for me.

If I set up a load sighted in for 100 yds and check out the Table Data, I should be able to t ...