Search found 4 matches

[quote="txtaxman"]Knowing that DallanC’s plate is full, I offer the following as an interim solution to new powders.

PointBlank draws from the data files and their respective user files. User da ...

Accurate Arms 4064
Here are a few I found not in the software. I go this from the powder burn chart from the IMR site but, notice some inconsistencies but, I think those below are correct.

Alliant ...

That is awesome. Thank you I will check the some of the powder vendors and see if I notice any.

I've been using Hodgdon CFE 223 and IMR7977. I do not see these in the drop down selection after choosing the powder manufacturer. Can those be added easily?

Thank you.