Search found 10 matches

The correct depth is 0.131"

RCBS got back to me - the cutter is supposed to be factory set at 0.131" for large rifle primers

The cutter is set at about 0.140"
I have been advised that the proper depth is 0.128" - 0.132"

Do you know what the SAMMI specs are?

Still dealing with Primer Pockets

I have a RCBS Large Rifle Primer Uniformer Tool that screws into the Trim Mate.

How the heck do you adjust the depth of cut. It has a set screw on the side, I ...

Thanks, I'll give that a try Very Happy

Does anybody have a Barnes Reloading Data Manual?
Need reloading data for the 7 mm RM with Barnes 150 grain X Bullet. I am actually using the TSX bullet (not the XLC).
Most likely use IMR 4350, IMR ...

Have any of you had experience with the Barns Triple Shock? Barnes literature claims that it retains 100% of it's weight (rolls back a 4 leaf clover and doesn't come apart)

Using 7 RM, what bullets to you all prefer?

Last year I used a Nosler 160 accubond â€“ when right through, exit hole the same size as the entrance hole.

Thanks for the quick reply Very Happy

I just got a Primer Pocket Uniformer tool. What is the correct depth to set the cutter at? I think I read somewhere it was around 0.120â€ +/- how much?